1. Long-distance wireless transmission (up to 500m in open area, 10kbps air data rate). 2. Operating frequency range: 433 - 458.5MHz, with up to 255 communication channels. Maximum transmit power: 100mW (20dBm), adjustable in 10 levels. 3. Built-in MCU; communicates with external devices via serial port. Transmits up to 31 bytes at a time. 4. Supports one-to-one and one-to-many transparent transmission via ID settings. Changing the serial port baud rate automatically adjusts the wireless data transmission rate (10kbps–100kbps). 5. Features a three-minute configuration window after power-on during which the module can send and receive data normally. During this period, sending 'AT+ENABLE=1' enables AT command mode for parameter configuration. After three minutes, AT mode is no longer accessible and all commands are treated as regular data transmissions. Product Name: VHF/UHF Radio Modem RS485 Wireless Transceiver 20dBm 433MHz Transmitter and Receiver Working Voltage: 4.5V–5.5V Interface: RS485 (5V, GND, A+, B-) Frequency: 433MHz Transmit Power: -40 to +20dBm Receiver Sensitivity: -114dBm Operating Temperature: -25°C to +75°C Transparent Transmission Baud Rates: 1200, 2400, 4800, 9600 (default), 19200 bps Open Area Transmission Distance: Up to 500 meters Dimensions (without antenna): 74 x 24 x 16mm Recommended for use with two or more units: - For 2 units: Module 1 and Module 2 communicate bidirectionally. - For 3 or more units: One master unit and multiple slave units. Operates similarly to a wired RS485 bus. The master transmits data to all slaves; any slave can transmit data to the master and other slaves. Only one device may transmit at a time to avoid collisions. Applications: IP PTZ Camera Modbus temperature sensor LED Controller RS485 Relay modules Remote control and remote measurement systems Wireless meter reading Home automation Access control systems Smart metering Color: Blue Material: Plastic + Metal Package Contents: 2 x 433M-458M VHF/UHF Radio Modem RS485 Transceiver (with shell) Note: Light and display differences may cause slight variations in color appearance. Measurement error allowance: ±1–3cm.