Features: 1Keep the tires working within the specified pressure and temperature range at any time, reducing tire damage and prolonging the service life. 2Avoid excessive or uneven air pressure in the tires and reduce wearing on the suspension system. 3When the tire has high pressure / low pressure / high temperature, the alarm reminds the owner to pay attention to driving safety, and also help save fuel and money. 4Keep track of tire conditions, prevent tire air leakage and tire bursts, fuel saving and eco-friendly. 5Replacing OEM numbers for reference: 40700-3VU0A. Condition: 100% Brand New Item Type: Tire Pressure Sensor Color: As picture shown OEM: 40700-3VU0A Frequency: 433 MHz Fitment: Fits for Nissan Rogue 2014-2016 External tire pressure sensor installation steps: 1. Unscrew the valve bonnet 2. Screw in hexagonal nuts 3. Rotate to the corresponding tire according to the position of the sensor 4. Use a nut wrench to rotate the top tightening sensor in the opposite direction 5. Check for leaks with soapy water. Note: The external tire pressure sensor replaces the original tire bonnet position Built-in tire pressure sensor installation steps: 1. Remove the original tire air nozzle 2. Install the tire pressure sensor (the installation position is indicated on the sensor), this step requires tire picking 3. Inflate the tire and cover the mouthpiece 4, dynamic balancing machine test 5. Adjust and balance weight, install balance weight (must be cleaned and dried thoroughly) Tire pressure monitoring learning operation and precautions: a. Park the vehicle on a level surface and prepare an air pump or pump b. Turn off the brake, pull the handbrake, and turn the key to the 0N position (the whole car is powered on and does not ignite) c. Press the (MENU) key on the steering light operation lever to switch to the vehicle information bar and find the tire pressure monitoring interface (as shown in the front right figure) d. Press and hold the SET button for about 3 seconds to enter the tire pressure relearning interface. After the selection is completed, the horn will sound twice in succession, indicating that the tire pressure monitoring learning has begun (rear left) e. At this time, the left turn signal light is on (rear right), prompting the left front wheel to deflate (it can deflate) until the horn sounds, and the left turn signal is off, and the right turn signal is on. Finish learning and stop deflating The tire pressure learning sequence is: left front wheel-right front wheel-right rear wheel-left rear wheel: f. After the rear wheel is deflated, the horn will ring twice, indicating that the tire pressure monitoring learning is over. Package Included: 4 x Tire Pressure Sensor