<p>Package Includes 100 * Floor Kit for Tile Leveling System Features: </p> <p>1. Wear resistant, recyclable, reusable. </p> <p>2. Easy to use in DIY operation. </p> <p>3. Balance the tiles in the same horizontal position. </p> <p>4. Improve the speed of tile installation. </p> <p>5. Reduce installer fatigue \/ pressure. </p> <p>6. There is hardly any flat surface without cracks. </p> <p>7. This reduces the need for sharpening and polishing. </p> <p>8. Prevent shingles from moving during solidification. </p> <p>Features 1. Name: Tile Leveling System Floor Kit </p> <p>2. Model: D91955 </p> <p>3. Equipment: High quality PP + stainless steel </p> <p>4. Color: black + orange </p> <p>5. Applicable Brick Difference: 2-6mm \/ 0.08-0.24 </p> <p>6. Applicable tile thickness: 3-16 mm \/ 0.12-0.63 Directions for use Lay the first tile leaving more than 2 mm (with crossed joints). Close to the tile. Insert the T-pins next to the space between the tiles. Then turn 180 degrees and the T-needle is attached to the bottom of both tiles. Adjust the cover by hand \/ special wrench until both tiles are level. After leveling for about 5-6 hours, before the cement \/ adhesive is completely dry, rotate the cover in direction reverse and pull out the T-needle 180 degrees until the soil is removed. Avoid not removing the T-leveling tile system </p> <p>1. Ceramic tile joints are 2mm or more (cross joints are recommended) </p> <p>2. When leveling, the adhesive cement or tile cement around the T-type leveler should be cleaned. </p> <p>3. Remove the T-type straightener approximately 5-6 hours after leveling before the tile or cement binder is completely dry. </p> <p>Note 1. Due to the difference between monitor and lighting effect, the actual color of the item may be slightly different from the color shown in the pictures. Thank you </p> <p>2. Please allow slight measuring deviation due to manual measurement.</p>